DY-404 Leakage Liquid Response Training Platform

Release time：2024-06-30 22:00viewed：times

1. Experimental purpose:
The anaerobic biological treatment technology of leachate is not only used for organic sludge and high-concentration organic wastewater, but also can treat low-concentration sewage. Compared with aerobic biological treatment technology, anaerobic biological treatment has a series of obvious advantages such as high organic load, low sludge production and low energy consumption. Upflow anaerobic sludge bed (UASB) is a m*n structure of anaerobic biological treatment. It integrates anaerobic biological reaction and sedimentation separation, has high organic load and removal efficiency, and does not require stirring equipment. This model is a teaching experimental equipment for upflow anaerobic sludge bed. Through this experiment, we hope to achieve the following goals:
1. Understand the internal structure of UASB leachate anaerobic;
2. Master the start-up method of UASB leachate anaerobic and the formation mechanism of sludge;
3. Conduct dynamic tests on a cert*n sewage to determine the process parameters and the water quality of the treated water.
2. Technical indicators and parameters:
1. Ambient temperature: 5℃～40℃
2. Treated water volume: 2～5L/h
3. Designed inlet and outlet water quality range:
Inlet BOD5 1000～2000mg/L Outlet 50～100 mg/L
Inlet COD 2000～4000mg/L Outlet 150～300 mg/L
Inlet SS 100～300mg/L Outlet 20～50 mg/L
Inlet pH 6～9 Outlet 6～9
4. The diameter of the cylinder is Φ150mm×2000mm.
5. Device dimensions: 1300mm×450mm×2300mm
6. Power supply 220V single-phase three-wire power 800W.
III. M*n configuration:
1. 1 raw water tank: white PP board material, thickness 10mm, 300×300×400mm, with a dr*n valve installed on the bottom plate to dr*n the water;
2. 1 clean water tank: white PP board material, thickness 10mm, 200×300×400mm, with a dr*n valve installed on the bottom plate to dr*n the water;
3. Equipped with 1 raw water tank stirring motor and 1 set of 304 st*nless steel stirring paddles; (power 25W, speed 120rpm), (including 1 speed regulator)
4. One set of UASB anaerobic reactor device, with jacket insulation, 5 copper sampling ports, made of transparent plexiglass, 7mm wall thickness, Ø150×2000mm, and a three-phase separator on the upper part, with water inlet valve, mud discharge valve, water outlet valve, gas valve, etc. Accessories include: 1 set of st*nless steel constant temperature water bath, 1 set of constant temperature water jacket (generally m*nt*ned at 35-45 degrees), 1 set of circulating constant flow water pump (maximum head 10m, rated flow 12L/min, power 90W), 1 set of temperature control system (temperature control accuracy: ±1℃), 1 PT100 temperature sensor
; 5. 1 set of water inlet metering peristaltic pump, flow range: 0.008-460mL/min,
6. 1 set of biogas flowmeter
7. 1 set of programmable automatic controller,
8. Power supply control system: 1 double-sided matte dense pattern spray-coated electric control box, leakage protector (Delixi brand), voltmeter, lockable button switch, wire pipe, etc.,
9. Matching UPVC connecting pipes and valves (Zhongc* brand).
10. St*nless steel frame laboratory table (30mm×30mm st*nless steel square tube, with casters as universal wheels with locking feet), etc.
11. Virtual simulation software for electrical installation of building and intelligent building Designed based on unity3d, users can choose different sizes of interactive interface according to computer configuration, and can choose six levels of image quality. The model in the software can be rotated 360°, enlarged, reduced, and translated. There are assistant prompts during the use of the software, as follows: A. Wet alarm system 1. System overview: Overview of wet alarm system 2. Equipment recognition: It has the best viewing angle, equipment det*ls (displaying the introduction or parameters of the equipment), exercises (built-in 6 multiple-choice questions, with prompts for correct and wrong choices), schematic diagram (you can enter the equipment from the schematic diagram). The equipment includes: sprinkler, water flow indicator, signal butterfly valve, exhaust valve, fire alarm control, high pressure gauge, high-level water tank, Wia control cabinet, pressure regulating tank, flow switch, end water test device, dr*nage facilities, water pump connector, hydraulic alarm, delay, wet alarm, butterfly valve, check valve, fire pump, safety pressure regulating valve, fire water tank. 3. Principle display: Display the working principle of the wet alarm system, 3D animation demonstration, 3D model is semi-transparent, and the internal water flow can be seen. Equipped with exercise module (4 multiple-choice questions are built-in, and there are prompts for correct and wrong choices) 4. Design layout: There are multiple-choice questions and calculation questions, each of which is scored, and the correct answer and score are displayed after submission B. Gas fire extinguishing system 1. System overview: Overview of gas fire extinguishing system 2. Equipment recognition: There are optimal viewing angles, equipment det*ls (displaying the introduction or parameters of the equipment), exercises (8 built-in multiple-choice questions, and there are prompts for correct and wrong choices), and schematic diagrams (you can enter the equipment from the schematic diagram). The equipment includes: nozzles, HFC-227 storage bottles, bottle head valves, heptafluoropropane check valves, high-pressure hoses, gas check valves, safety valves, weighing alarms, electromagnetic starters, selection valves, smoke alarms, and fire alarm controllers. 3. Principle display: Display the working principle of the gas fire extinguishing system, 3D animation demonstrations, and 3D models are semi-transparent, and the internal gas can be seen. Equipped with a practice module (built-in 3 multiple-choice questions, with prompts for correct and incorrect choices) 4. Design layout: There are 6 multiple-choice questions, each with a score, and the correct answer and score will be displayed after submission
C. Escape drill: Teaching in the form of fun games, escaping from the burning room within a limited time. If you make a mistake, you will directly enter the score interface.
Similar products:

ZR-405 type Leachate small-scale experimental device	Mn parameters and configuration: Treatment of leakage liquid: 50 ~ 100L / h, device dimensions: 4000mm × 500mm × 2300mm, power supply 220V power 500W, configuration: water tank 250L, water pump, flow meter, organic glass coagulation sedimentation (stirring device) organic glass UASB reactor (accessories: dosing metering pump, heating circulation pump, wet gas flow meter, heating thermostat, temperature control device, organic glass anaerobic tank, MBR tank (accessories: diaphragm pump, membrane assembly, fan, gas flow meter, liquid flow meter, water outlet flow meter, connecting pipe, valve, stnless steel bracket with movable wheels.
ZR-409 type Solid waste leachate reaction experiment	Mn parameters and configuration: Device dimensions: 1500mm×500mm×1300mm, power supply 220V, power 500W, configuration: 1 set of anaerobic tank, 1 set of aerobic tank, 1 set of membrane reaction tank, 1 water pump, 1 suction pump, 1 r pump, 1 set of motor stirrer, 1 set of aeration device, 1 water flow meter, 2 gas flow meters, 1 set of membrane assembly, 1 electric control box, leakage protection switch, push button switch, connecting pipes and ball valves, st*nless steel stand with movable wheels, etc.
ZR-410 type Intermittent experiment of photocatalytic leakage liquid (first-level experimental treatment)	Mn parameters and configuration: Leakage liquid treatment water volume: 5~10L/h, device dimensions: 700mm×450mm×1600mm, power supply 220V power 300W, configuration: 2 water reservoirs, 1 water pump, 1 set of photocatalytic reaction column, 1 quartz tube, 1 UV lamp, 1 flow meter, 1 r pump, 1 gas flow meter, 1 ozone generator, 1 electric control box, leakage protection switch, push button switch, connecting pipes and ball valves, st*nless steel stand with movable wheels, etc.
ZR-411 type Intermittent experiment of photocatalytic leakage liquid (secondary experimental treatment)	Mn parameters and configuration: Leakage liquid treatment water volume: 5-10L/h, device dimensions: 1100mm×800mm×1600mm, power supply 220V, power 1000W, configuration: 2 water reservoirs, 1 water pump, 1 set of primary photocatalytic reaction column, 1 set of secondary photocatalytic reaction tank, 1 quartz tube, 1 ultraviolet lamp, 3 flow meters, 1 r pump, 1 xenon lamp, 1 ozone generator, 1 mixing tank, 1 electric control box, leakage protection switch, push button switch, connecting pipes and ball valves, st*nless steel stand with movable wheels, etc.
ZR-412 type Electrolysis leakage liquid membrane reaction experiment	Mn parameters and configuration: water treatment volume: 5-8L/h, device dimensions: 1720mm×500mm×1300mm, power supply 220V power 1000W, configuration: plexiglass leakage liquid pool, water distribution tank, water pump, water flow meter, sedimentation tank, micro-electrolyzer (with DC power supply), gas flow meter, membrane biological aeration tank, diaphragm pump, water outlet flow meter, 1 electric control box, leakage protection switch, push button switch, connecting pipes and ball valves, stnless steel stand with movable wheels, etc.

Previous：DY-402 Landfill Column Training Platform

Next：DYHGRG-64 Enthalpy Difference Method Air Conditioning Training Platform