ARM Embedded Training Device

ARM Embedded Tr--ning Device,Hybrid car simulation tr--ning desk

1. Core board hardware parameters

1.1CPU: OMAP3530 DCUS, 600-MHz ARM Cortex-A8 Core 412-MHZ TMS320C64X+ DSP Core, integrated memory for ARM CPU (16KB I-Cache, 16KB D-Cache, 256kb L2) and chip storage (64KB SRA M, 112KB ROM Cure

1.2DDR RAM: 256MB DDR RAM MT29C2G48MAKLCJA-6IT

1.3Flash: 256MB NAND Flash MT29C2G48maklcja-6IT

1.4 Power Management: Independent Power Management Chip TPS65930

1.5LDO: With LDO

2. Belly hardware parameter

2.1fpga: XC3S250E-P208 is used to control logic and expand serial ports, allocate the corresponding device allocation address

2.2 Ethernet: 1 10/100M adaptive Ethernet controller DM9000A

2.3LED: 12 GPIO -controlled LED working status instructions: 6 are located on the core board, 6 are located on the bottom board

2.4 Audio: Standard AC97 Audio Controller Small Three Core interface+MIC head TPS65930

2.5 reset: isolated internal and external reset signals, increase reset reliability TC7SH08FU

2.6UART: A total of 7 UART: 3 processor comes with it, 4th road FPGA expansion, of which 1 connecting infrared 2 -way expansion interface 4 road connection DB9 connector

2.7RTC: Independent RTC 1220 battery power supply

2.87 -inch LCD: 7 -inch 24 -bit LCD screen strips resistance screen 16: 9 Display, resolution: 800 × 480 connected on DSS (AT070TN83)

ARM Embedded Tr--ning Device,Hybrid car simulation tr--ning desk

I. Overview

This equipment can display the car oil and electricity hybrid power system, and simulate the energy flow direction of the energy flow under the start, low -speed driving, general driving, full -speed driving, deceleration and parking of parking, and the operating status of the motor. Hybrid power system work conditions.

Applicable to the teaching needs of the mixed power vehicle energy system of "New Energy Vehicle and Electronic Technology".

Second, structure composition

The device is launched by start switch, throttle pedal, gear switch, brake switch, digital speed meter, current indicator table, etc., and supplemented by the dynamic indicator of the system flow with the light emitting diode. Figures, control panels, mobile tables, use operation manuals, etc.

Third, functional characteristics

1. The device fully demonstrates the mixed -connected hybrid system, which can dynamically simulate the energy flow direction of the six types of energy flow under the start, low -speed driving, general driving, full -speed driving, deceleration, and parking As well as the running status of the generator, the characteristics and advantages of dynamically display the car hybrid power system.

2. Install a ignition switch, work condition switch, throttle pedal, gear switch, brake switch, digital speed meter, current indicator table, etc., supplemented by the dynamic instructions for system flowing in the light -emitting diode, and set it up. There are three analog motors used to demonstrate the working status of the engine, motor and generator.

3. The appearance of the teaching plate panel is beautiful; the bottom part is welded with steel structure, the surface is treated with spraying process, a self -locking wheel device, and a desktop of about 30cm on the profile base, which is convenient for placing data and light detection instruments.

4. Machinery assembly and fitter assembly virtual simulation software: This software is developed based on Unity3D, which can choose 6 -level image quality. It has the design and virtual disassembly of the reducer and shaft structure, the design and simulation of common mechanical institutions, institutional resource libraries, institutional resource libraries. Typical mechanical institutions (virtual disassembly of gasoline engines), software is an overall software, which cannot be separate resources.